How To Clean Resin Out Of An Ash Catcher

• #1

Can i eddy my bong slides and ash catcher ? Thanks RIU

• #2

common salt and rubbing alcohol.

• #4

common salt and rubbing alcohol.

merely need a lil bit? let it sit for a hr or so?

• #5

use rubbing booze and coarse table salt and only shake 'em upwardly.. y'all tin can allow them just soak in the alcohol likewise

oh ok thanks guys 90% h2o sounds good?

• #6

no water. only alcohol and salt.

i put mine in a plastic baggy so add booze and salt. then close and milkshake until make clean. if it's actually heavy i scrape the goo out first then let it soak overnight in the amorphous.

• #vii

no water. just booze and common salt.

i put mine in a plastic baggy so add alcohol and table salt. then shut and shake until clean. if it'due south actually heavy i scrape the goo out offset then let it soak overnight in the baggy.

alright that sounds uncomplicated plenty but equally for the bell its 3feet tall and has 3 percolators and very dirty.... information technology was given to me from a friend who never cleaned it in yrs or some shit. the bell tastes disgusting weed isnt even worth smoking in it. Then just get alot of rubbing alcohol and fill it up? or any other ideas?

• #viii

alright that sounds simple enough but as for the bell its 3feet alpine and has 3 percolators and very dirty.... information technology was given to me from a friend who never cleaned it in yrs or some shit. the bong tastes disgusting weed isnt fifty-fifty worth smoking in it. So just get alot of rubbing alcohol and fill it upward? or any other ideas?

bongs are a bowwow. i add together a bunch of alcohol and salt. cover the end with my palm and start shaking.

• #nine

Take out all the slides and whatnot, duct tape over information technology, and the carb if there is i. Put your hand over the mouthpiece, and brand sure every perc has some table salt and alcohol in it. Shake it up and downwardly.

Don't put it in humid water. If you do that wrong information technology will crack.

• #10

i also use fdd'ed method for cleaning.. and with that bong.. just observe something to plug up the carbs with and any other holes that the alcohol may leak from.. with one that big your best bet me be sitting it in the tub or a big laundry sink or something along those lines... fill it with equally much booze every bit yous can and only let it soak overnite or however long... later on it soaks for awhile, practice the milk shake that fdd'ed said.. the resin should just come running out... if it is likewise big to make clean all at once, endeavour to intermission the procedure down to a few steps, similar get 1 surface area clean first, and so move onto some other area so along.. it may take a few days to get her all make clean, but your taste glands volition love you for it..

• #11

y'all guys merely reminded me to clean out this nasty ass slice. but took about ten 15 minutes of shaking in a handbag to get the burnt nasty crusty stuff from the cone within of the bowl. i dont think that drinking glass hasw seen daylight in years and at present its equally clean as the 24-hour interval i bought it. non a spec of resin.

• #12

so i cleaned the ashcatcher slide etc came out looking brand spanking new thank you guys. Ya for the bong i probably wont shake it or anything merely let information technology sit... the top percolator bankrupt off and information technology only dangles inside the bong and cant come out b/c the ice catcher and so shaking might just interruption glass all over the identify.

Source: https://www.rollitup.org/t/boiling-water-removed-resin-from-glass.279021/

Posted by: castillohologe.blogspot.com

Share this post